Henan Changxing Refractory Material Co.,Ltd.





Industry Dynamic
Providing Free technical guidance & Best Products
Emai: info@cxrefractories.com
With the development of modern dry-process cement production technology, there has been significant progress in the corresponding refractory materials. Beyond breakthroughs in conventional refractory bricks, the performance of refractory castables has also been continuously refined, leading to their widespread use in the non-shaped (monolithic) sections of kilns. As is well known, refractory castables are uncalcined, monolithic refractory materials composed of a specific blend of refractory aggregates, powders, and binders. When mixed with water during installation, they exhibit excellent flowability; once shaped and cured—a process that includes heating according to a specific temperature regimen—they set and harden. The operational advantages of refractory castables include: first, they result in structures with fewer joints, greater overall integrity, and superior sealing, which prevents clinker dust from penetrating the lining during operation; second, they are easy to anchor and install, thereby enhancing both the efficiency and quality of the lining construction; and third, they can be produced from a wide range of raw materials, facilitating the comprehensive utilization of resources. Furthermore, their short lead times help reduce inventory levels and associated carrying costs. Given these benefits, the proportion of refractory castables used in cement clinker production systems has been increasing year by year; for instance, in a 5,000 t/d modern dry-process kiln, the ratio of refractory castables to refractory bricks has reached 1:1.
In simple terms, a refractory castable is a type of high-temperature-resistant concrete; therefore, it adheres to the same fundamental principles as concrete. For instance, the amount of water added is the critical factor in determining whether a refractory castable can achieve its designed strength. Driven by profit motives, some contractors may add excessive water to the mix to accelerate the construction process. This significantly shortens the service life of the refractory lining in the kiln—often leading to severe issues within just six months and necessitating major repairs—whereas a properly installed refractory lining can typically last for three to five years without requiring such extensive maintenance. Although the investment in refractory materials accounts for only a small fraction (approximately 2%–4%) of the total capital expenditure for a plant, it exerts a profound influence on the long-term operation of the entire system. Given that a single day of unplanned downtime caused by a refractory lining failure can result in losses ranging from hundreds of thousands to over a million yuan, ensuring a high operational rate for the firing system is essential to achieving high-quality, high-yield, and low-consumption production.
(1) The amount of water added to the castable must be strictly controlled in accordance with the manufacturer’s instructions and must not exceed the specified limit. While ensuring proper workability for installation, the amount of water used should be kept to the minimum necessary.
(2) The castable must be mixed for at least 5 minutes using a forced-action mixer. The mixing process should begin with a dry mix, followed by the addition of 80% of the required water. The remaining water should then be added gradually—while monitoring the consistency—until the desired workability is achieved.
(3) Once poured into the formwork, the castable must be immediately compacted in layers using a vibrator. Each layer should not exceed 300 mm in height, and the vibration points should be spaced approximately 250 mm apart. During vibration, care must be taken to avoid contact with anchors or damage to the insulation layer. Prolonged or repeated vibration in the same spot must be avoided. Once mortar rises to the surface, the vibrator should be withdrawn slowly to prevent segregation of the material or the formation of voids.
(4) For large-area pours, the work should be divided into sections, with each section covering approximately 1.5 m². Expansion joints must be incorporated as per the design specifications—ensuring none are omitted—and should be positioned midway between the anchors.
E-mail:info@cxrefractories.com
Tel:+86-371-88888998
Fax:+86-371-88886886
Address:South Tower, Greenland Central Plaza, Zhengzhou, Henan Province, China